|
SO, YOU WANNA MAKE A SPUDGUN.....
--------------------------------------------------------------------------
All you need are the materials listed below to build a simple combustion spudgun.
SETUP #1
'FOUR INCH CHAMBER'
THINGS YOU NEED:
MAKE SURE YOU ARE CONSISTENT IN THE TYPE OF PIPE YOU CHOSE. DO NOT SWAP PVC OR ABS!
A foot of 4 inch PVC or ABS Pipe
4" end cap with threaded back
4" clean out threaded plug
4" - 2" inch bell reducer **
2" - 1½" bushing **
3-4' of 1½," PVC or ABS Pipe
Small container of PVC or ABS cement (depending on what type of pipe is used)
** If you are able to get a 4"- 1½" reducer, then you will not need the bushing
Once you have all the materials listed, assemble all of them like that on SETUP #1 on this page. (This won't be all you need to completely finish your spudgun.)
»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»
SETUP #2
'THE ELONGATED CHAMBER'
|