SO, YOU WANNA MAKE A SPUDGUN.....
--------------------------------------------------------------------------






All you need are the materials listed below to build a simple combustion spudgun.



 SETUP #1     
'FOUR INCH CHAMBER'







THINGS YOU NEED:

MAKE SURE YOU ARE CONSISTENT IN THE TYPE OF PIPE YOU CHOSE.  DO NOT SWAP PVC OR  ABS!


A foot of 4 inch PVC or ABS Pipe
4" end cap with threaded back
4" clean out threaded plug
4" - 2" inch bell reducer **
2" - 1½" bushing **
3-4' of 1½," PVC or ABS Pipe
Small container of PVC or ABS cement (depending on what type of pipe is used)



** If you are able to get a 4"- 1½" reducer, then you will not need the bushing




Once you have all the materials listed, assemble all of them like that on SETUP #1 on this page.  (This won't be all you need to completely finish your spudgun.)


»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»»

 

SETUP #2
'THE ELONGATED CHAMBER'